››Note details

Kodak Camera Won’t Turn On? Try This Easy Battery Fix

BY cn1ae

July 22, 2025•

Public

Private

1886 views

Troubleshooting Kodak Cameras That Won't Turn On (AA Batteries)

This document provides a step-by-step troubleshooting guide for Kodak cameras using AA batteries that refuse to power on.

Use the Correct Batteries
- Always use fresh 1.5V alkaline AA batteries (e.g., Duracell or Energizer).
- Avoid rechargeable (NiMH) batteries, as they're typically 1.2V and may not supply sufficient voltage.
Check Battery Orientation
- Ensure the plus and minus ends of the batteries match the diagram in the camera’s battery compartment.
Inspect and Clean Battery Terminals
- Look for corrosion or dirt on terminals.
- Clean gently with a pencil eraser or a cotton swab dipped in isopropyl alcohol.
- Dry terminals thoroughly.
Check Battery Spring Contacts
- Springs should press firmly against the battery ends.
- If loose, temporarily use a small paper shim to improve contact (temporary fix).
Minimize Power Load
- The camera’s flash uses extra power.
- Turn off flash, especially if using weaker batteries (like NiMH rechargeables).
Perform a Power Reset
- Remove batteries, wait 1–2 minutes, then reinsert correctly.
- This may reset the camera’s internal systems.
Inspect Power Button and Battery Door
- Press the power button firmly and hold for a few seconds.
- Ensure the battery door or latch is fully closed.
- Internal debris or a faulty button can cause power issues.
If All Else Fails
- Issues may be due to loose springs, failing internal components, or a defective motherboard.
- Seek professional camera repair or contact Kodak support.

If the guide was helpful, consider subscribing or leaving questions in the comments.